Bianca Basin Mixer Straight Spout Brushed Gold
$385.00 inc.GST
- DZR Brass Construction
- Brushed Gold Finish
- Straight Spout Design
- 6-Star WELS Rated
- 15-Year Warranty
Description
Straight spouts sit differently on a vanity than curved or angled alternatives — lower profile, cleaner geometry, and a presence that reads as considered rather than decorative. The Bianca Basin Mixer Straight Spout Brushed Gold from Ross’s range of basin mixer taps brings that restraint to gold tapware, a finish category that usually leans the other way.
The brushed gold finish diffuses light rather than reflecting it sharply — warmer than chrome, quieter than polished gold. It works against white, stone, and timber vanity surfaces without competing for attention. Paired with other gold tapware across the Bianca tapware range, the straight spout profile creates a cohesive bathroom scheme built around geometry rather than ornamentation.
Water efficiency is certified at 6 stars WELS at 4.5 litres per minute (Registration T40947) — the top rating available for basin mixers. WaterMark certification (Licence WM-060073) confirms compliance with Australian plumbing standards. Temperature ranges from 1°C to 75°C. Mains pressure ranges from 150 to 500 kPa via soft nylon PEX flexible hoses.
Low-lead DZR brass construction resists dezincification under Australian water conditions — structurally sound and safe for long-term drinking water contact. The NEOPERL aerator delivers a smooth, controlled stream at the spout without splashing across the basin surface. This gold mixer tap suits standard basin installations where spout height and finish consistency are the deciding factors.
The Bianca Basin Mixer Straight Spout Brushed Gold is available with Perth metro delivery. A 15-year warranty backs the unit from day one.
Check out our Basin Mixer Buying Guide to decide if a sensor tap is the best fit for your basin. And don’t forget to purchase a basin waste to go with your new tap!
FEATURES & BENEFITS
- Brushed Gold Finish: Diffuses light warmly — suits white, stone, and timber vanities without overpowering the scheme
- Straight Spout Profile: Clean horizontal geometry sits lower and quieter than curved or angled spout alternatives
- DZR Brass Construction: Dezincification-resistant body stays structurally sound and drinking-water safe long term
- 6-Star WELS Rating:5L/min (Registration T40947) — highest available efficiency rating for residential basin mixers
- Ceramic Disc Cartridge: Single lever controls temperature from 1°C–75°C with precise, energy-saving adjustment
- 150–500kpa Pressure Rated: Suits standard Australian mains pressure across residential bathroom installations
- NEOPERL Aerator: Controlled output at the spout eliminates basin splashing during daily hand washing routines
- Nylon PEX Hoses: Soft flexible hoses connect cleanly to standard Australian plumbing configurations
- WaterMark Certified: Licence WM-060073 confirms full compliance with Australian plumbing installation standards
- Bianca Range Compatible: Coordinates with gold tapware across the full Bianca bathroom collection
- 15-Year Warranty: Strong long-term backing reflects the quality of DZR brass construction throughout
Spec Sheet
Warranty
| Category | Warranty Period | Warranty Details |
|---|---|---|
| Mixer Taps | 15 years | -15 years Replacement Cartridge only -7 years Replacement products or parts on all finishes -1-year Replacement products or parts & Labour |
| Pearl & Kara tapware | 15 years | -15 years Replacement Cartridge only -7 years Replacement products or parts on all finishes -1-year Replacement products or parts & Labour |
| Showers | 10 years | -10 years Replacement products or parts on chrome finishes. Note: Metal Shower hoses only have 5 years replacement warranty -10 years Replacement products or parts on other finishes -1-year replacement products or parts & Labour |
| Bath Outlets | 10 years | -10 years replacement products or parts only on all finish |
| Bathroom Accessories | 1 year | -1-year Replacement products or parts only |
| Other Accessories | 10 years | -10 years on universal pop up waste replacement only -1 year on bottle trap replacement only |
-
*NOTE:
Cartridge replacement excludes damage to Ceramic discs from pieces of copper tube, plastic, sand, dirt or thread tape etc.
Pull-out nozzle and hose 1-year parts only.
In addition to the guarantees under the Australian Consumer Law, Nero tapware warranty periods apply to products purchased after 1st December 2019
-
WARRANTY SHALL BE VOIDED FOR THE FOLLOWING REASONS:
Inability to provide proof of purchase or equivalent documentation
Products not installed by a licensed plumber. (Excludes Bathroom accessories – towel rails, shelves etc.)
Products not installed to relevant National Standards and State Regulations.
Products not installed in accordance with the manufacturer’s installation instructions
Tapware exposed to water pressures and or temperatures that exceed stated limitations as per the product installation instructions. Note: AS/NZS 3500, 1-2003 (clause 3.3.4) specifies 500KPA maximum water supply pressure at any outlet within a building for new installations.
Fitting of other devices to the outlet of tapware. E.g. Water filters
Fitting of Nero Taps non-approved in tap body or end of line water flow regulating devices
Products used for incorrect applications, non-potable water etc.
Damage as a result of obstructions due to inadequate flushing of system before use.
Service, repairs or non-standard replacement parts previously undertaken without NERO Taps written approval.
Damage to finishes by adhesives, sealant etc.
Damage to finishes that arise from installation or post-installation use
Failure to observe manufacturer’s care and cleaning instructions
Improper or abusive use of product, and/or damage resulting from misuse, accident or neglect
-
WARRANTY CONDITIONS
Nero tapware warranty covers the repair or, at its option, replace any goods which are defective through faulty workmanship or materials, free of charge and labour, within the first 1 years of the warranty.
The warranty period commences from the date of purchase or, for new buildings, the date of handover. To make a warranty claim, proof of purchase, handover documentation for new homes or equivalent documentation must be supplied for warranty claims to be considered. All claims are to be lodged at the point of purchase, whereby Sussex Taps After Sales Service Department will then be notified.
Nero tapware will not be liable for any subsequent claims of labour, additional products or parts associated with the alleged faulty product for work not approved in advance in writing by Nero tapware.
Should any warranty claim be made and service attended to by a Nero tapware authorized Service Agent whereby the installation has been assessed as an installation fault and not a product fault, or from some other cause other than a manufacturing defect, Nero tapware reserves the right to charge a service fee for attending and/or any work carried out.
Nero tapware require adequate access to products, fittings and fixtures to undertake warranty repairs. Nero tapware will not be responsible for any consequential damage or costs where adequate access to product fittings and fixtures is not provided.
-
TAPWARE AND ACCESSORIES CARE AND CLEANING INSTRUCTION
Under no circumstances should you install tapware using acetone silicones.
Never use harsh detergents or abrasive cleaners, as these will scratch the surface.
To clean, use a soft cloth with warm soapy water to maintain the finish in perfect condition for a lifetime of use.
Use of wax-based furniture cream should be avoided as this can result in a build-up of deposits, which could detract from the appearance.
Gold and Rose Gold plated products should always be cleaned with care using a soft dry cloth or a soft cloth with warm soapy water.
Note: This is a summary of the Nero tapware warranty offer for Australian installed products. Some additional terms and conditions may apply.
Nero tapware reserves the right to alter, or amend this warranty offer in writing at any time. Nero tapware reserves the right to provide minor components (eg. handles, aerators, buttons, dress rings, spindle/cartridges and seals) as ‘ Parts Only’ to the customer.
-
CONSEQUENTIAL LOSS
Nero tapware obligations under warranty are limited to the repair or, at Nero option, replacement of any products which are defective through faulty workmanship or materials. To the extent permitted by law, Nero tapware will not be liable for any loss to furniture, floor coverings, walls, fixtures or any consequential loss of any kind caused by any defect in the product components.
Full Warranty Details can be found here – https://nerotapware.com.au/warranty-policy/
Reviews
There are no reviews yet